Toshiba e-STUDIO 2555C Service Manual page 655

[EA70] Stack exit belt home position error / Stack slider home position error
Classification
Paper jam in finisher section
MJ-1107
Check item
Stack belt exit home position
sensor
Stack transport motor
Parts to be replaced
Stack belt exit home position
sensor
Stack transport motor
Finisher controller PC board
MJ-1108
Check item
Stack belt exit home position
sensor
Stack transport motor
Parts to be replaced
Stack belt exit home position
sensor
Stack transport motor
Finisher controller PC board
© 2012-2013 TOSHIBA TEC CORPORATION All rights reserved
Error content
Stack exit belt home position error / Stack slider home position error
Measures
Check if there is a disconnection of the connector, incorrect
installation or breakage of the stack belt exit home position sensor
(S9). If there is, reinstall the sensor correctly or replace it.
Check if the connector CN11 on the finisher controller PC board is
disconnected from the stack belt exit home position sensor (S9) and
the harnesses are open circuited. Correct if any.
Is the harness between the stack transport motor (M5) and the
finisher control PC board (CN10) disconnected or open circuited?
Remark
Measures
Check if there is a disconnection of the connector, incorrect
installation or breakage of the stack belt exit home position sensor
(S9). If there is, reinstall the sensor correctly or replace it.
Check if the connector (CN18) on the finisher controller PC board is
disconnected from the stack belt exit home position sensor (S9) and
the harnesses are open circuited. Correct if any.
Check if the connector (CN17) on the finisher controller PC board is
disconnected from the stack transport motor (M8) and the
harnesses are open circuited. Correct if any.
Remark
8 - 99
e-STUDIO2555C/3055C/3555C/4555C/5055C
ERROR CODE AND TROUBLESHOOTING
8