Toshiba e-STUDIO 2555C Service Manual page 1086

Sub
05/08 Mode Element
element
05 Adjustmen Scanner Scanner
t mode
05 Adjustmen Scanner Scanner Size detection of
t mode original
05 Adjustmen Scanner Scanner Size detection of
t mode original
05 Adjustmen Scanner Scanner Size detection of
t mode original
05 Adjustmen Scanner Scanner Size detection of
t mode original
05 Adjustmen Printer Image Adj. of primary scan.
t mode writing start
05 Adjustmen Printer Drive Fine adjustment of
t mode system ADU motor rotational
speed
05 Adjustmen Printer Drive Fine adjustment of
t mode system ADU motor rotational
speed
05 Adjustmen Printer Drive Fine adjustment of
t mode system ADU motor rotational
speed
05 Adjustmen Printer Drive Fine adjustment of
t mode system ADU motor rotational
speed
05 Adjustmen Printer Drive Fine adjustment of
t mode system ADU motor rotational
speed
05 Adjustmen Printer Drive Fine adjustment of
t mode system ADU motor rotational
speed
Item Subitem Code
3218
3233
3234
3236
3237
4006
4016
4016
4016
4016
4016
4016
Sub- Default Acceptable
Details
code value value
Shading correction - -
plate Automatic dust
detection adjustment
Position adjustment in 128 0-255
the primary scanning
direction
Waiting position 200 0-255
adjustment of carriage
Adjustment of lamp 128 0-255
lighting time
Starting time 64 0-255
adjustment of lamp
lighting
ALL 128 0-255
0 Transport speed: 128 0-255
Normal speed
4 Transport speed: 128 0-255
Decelerating
8 Transport speed1 128 0-255
9 Transport speed2 128 0-255
10 Transport speed3 128 0-255
11 Transport speed4 128 0-255
27
RAM Contents
- Performs adjustment for automatic dust detection with
the shading correction plate. If dust is detected, shading
correction is performed by avoiding the dust.
SYS Adjusts the detection range for size of original.
SYS Adjusts the position where the carriage stops at the size
detection of the original.
Default value: 100 (10 mm from leading edge of
original)
Maximum value: 255 (25.5 mm from leading edge of
original)
Minimum value: 0 (0 mm from leading edge of original)
SYS Adjusts the lighting time of the lamp at the size
detection of the original.
Maximum value: 255 (Minimum time + 2040ms)
Minimum value: 0 (Minimum time)
SYS Adjusts the starting time of lamp lighting when the
detection accuracy of dark originals is poor.
Maximum value: 255 (Minimum time + 2040 ms)
Minimum value: 0 (Minimum time)
M When the value increases by "1", the writing start
position shifts to the front side by approx. 0.0423 mm.
M 0.1%/step
M 0.1%/step
M 0.1%/step
M 0.1%/step
M 0.1%/step
M 0.1%/step
Proce Servic
dure e UI
6
1
1
1
1
1 Yes
4
4
4
4
4
4