Surrounding Void Amount Adjustment - Toshiba e-STUDIO 2555C Service Manual

6.4.11 Adjustment of the capacity and image quality of SlimPDF
The compression quality or the resolution is adjusted to reduce the file capacity of a SlimPDF or
improve its quality.
<Adjustment Mode (05)>
Item to be
Code
adjusted
9104 Compression
quality of
SlimPDF
background
processing
9107 Resolution of
SlimPDF
background
processing
<Procedure>
(1) While pressing [0] and [5] simultaneously, turn the power ON.
(2) Key in the codes to be adjusted and press the [START] button.
(3) Key in the adjustment value. (To correct a value once keyed in, press the [CLEAR] button.)
(4) Press the [OK] or [INTERRUPT] button to store the value in memory. -> The equipment goes
back to the ready state.
(5) Let the equipment restart. Acquire the SlimPDF file and check it.
(6) If the desired image quality has not been attained, repeat step (1) to (5).
6.4.12

Surrounding void amount adjustment

The void amount around the network scanned image is adjusted.
In network scanning, since the void amount is very small in stored images, a shadow may appear
around the scanned image due to the subtle difference in the original sizes. This shadow can be
eliminated by adjusting the setting value.
The setting value is applied to all resolutions and color modes.
<Adjustment Mode (05)>
Code Item to be adjusted
7489 Surrounding void
amount adjustment
<Procedure>
The procedure is the same as that of  P. 6-68 "6.4.2 Density adjustment".
e-STUDIO2555C/3055C/3555C/4555C/5055C
SETTING / ADJUSTMENT
The smaller the value, the less the file capacity and the lower the
image quality becomes. The larger the value, the greater the file
capacity and the higher the image quality becomes.
Acceptable values: 0 to 10 (Default: 5)
The smaller the value, the less the file capacity and the lower the
image quality becomes. The larger the value, the greater the file
capacity and the higher the image quality becomes.
0: 75dpi
1: 100dpi
2: 150dpi
3: 200dpi
Acceptable values: 0 to 3 (Default: 1)
Remarks
When the value increases, the blank area around the scanned
image becomes wider, and the data on the image decrease.
Acceptable values: 0 to 255 (Default: 0)
The setting value "1" is equal to 1 dot with 600 dpi. (The value
"24" is equal to approx. 1 mm.)
© 2012-2013 TOSHIBA TEC CORPORATION All rights reserved
6 - 74
Remarks