Toshiba e-STUDIO 2555C Service Manual page 437

<Procedure>
[ 0 ][ 5 ]
( Code ) [ START ]
[ Power ]
[ OK ] or
[ INTERRUPT ]
Stores in memory
(*1) 1: Single-sided grid pattern in Black Mode
3: Double-sided grid pattern in Black Mode
55: Grid pattern of thick paper 2 in Full Color Mode
56: Grid pattern of thick paper 3 in Full Color Mode
57: Grid pattern of OHP film in Full Color Mode
58: Single-sided grid pattern of thick paper 2 in Black Mode
59: Single-sided grid pattern of thick paper 3 in Black Mode
60: Single-sided grid pattern of OHP film in Black Mode
98:
Single-sided grid pattern in K(4)
K(4)*: System in which the test pattern is printed only in the black mode, though the four color
developers (Y, M, C, K) are contacted to the transfer belt.
Notes:
If the aligning amount is too large, abnormal noise (paper-folding noise) or actual paper folding
may occur during paper feeding. If the aligning amount is too small, on the other hand, a skew,
an image dislocation in feeding direction, E010 (Jam not reaching the exit sensor), E011
(Transfer belt paper-clinging jam), or E013 (The paper jam occurred between the registration
pass sensor and the paper clinging detection sensor) may occur. Pay attention to the above and
select the appropriate value.
© 2012-2013 TOSHIBA TEC CORPORATION All rights reserved
( Not necessary for LCF )
( Sub-code ) [ START ]
[ Drawer
selection ]
Fig.6-11
*
Mode
6 - 11
Enter new
Current value
displayed value
[ POWER ]
*1
[ ] + [ FAX ]
( Test print )
e-STUDIO2555C/3055C/3555C/4555C/5055C
SETTING / ADJUSTMENT
OFF/ON
( Exit )
6