Toshiba e-STUDIO 2555C Service Manual page 1054

PFP lower drawer paper width
A
detection sensor 3
PFP lower drawer paper width
B
detection sensor 2
PFP lower drawer paper width
C
detection sensor 1
PFP lower drawer paper width
D
detection sensor 0
[7]
PFP lower drawer paper length
E
detection sensor 3
PFP lower drawer paper length
F
detection sensor 2
PFP lower drawer paper length
G
detection sensor 1
PFP lower drawer paper length
H
detection sensor 0
A LCF tray-up sensor
LCF tray detection sensor (feeding
B
side)
C LCF empty sensor (feeding side)
D LCF nearly empty sensor (feeding side) Nearly empty
[8]
E LCF tray bottom sensor
F -
G LCF end fence stop position sensor
H LCF end fence home position sensor
LCF jam releasing cover
A
opening/closing detection
B LCF tray detection (standby side)
C Empty sensor at LCF standby side
D -
[9]
LCF standby side paper misload
E
F LCF transport sensor
G -
H LCF motor
A -
B -
C -
D Security enabler
[0] Judgement for acceptable USB storage
E
device (*1)
F -
G -
H -
*1
- Be sure to install the USB storage device to the equipment and check if the device can be used
with this code.
- Be sure to turn OFF the write protection (the function to prevent data from erasure by the accidental
recording or deleting) of the USB storage device before performing the check, otherwise this code
cannot be used.
- It may take some time (2 sec. to 10 sec.) before this check is completed depending on the USB
storage device.
OFF ON
OFF ON
OFF ON
OFF ON
OFF ON
OFF ON
OFF ON
OFF ON
Tray at upper limit Other than upper
position limit position
Open Closed
Paper present No paper
Normal
Tray at bottom Other than bottom
position position
- -
Position after tray Other than position
transport after tray transport
Other than home
Home position
position
Closed Open
Open Closed
No paper Paper present
- -
Properly loaded Paper misload
No paper Paper present
- -
Accelerating/Deceler
Normal rotation
ating/Stopped
- -
- -
- -
Connectable Not connectable
Acceptable Not acceptable
- -
- -
- -