Backup Files - Toshiba e-STUDIO 2555C Service Manual

12.1.3

Backup files

The following files are saved in the root directory of the USB device by backing up.
Filename
Modelname_MFPSerialNo_yyyy-MM-dd_hh-mm
12.1.4 Cloning procedure
[A] Backup procedure
(1) Press the [ON/OFF] button to shut down the equipment.
(2) Connect the USB device [1] to the USB port [2] on the right upper cover.
Notes:
Backing up cannot be performed with multiple USB device [1] connected at the same time.
(3) Turn the power ON while pressing [6] and the [CLEAR] button simultaneously.
(4) When "SRAM Clear Mode" appears on the LCD, key in [0] to select "0. Set Serial Number" and
then press the [START] button.
(5) Key in the serial number on the label attached to the rear cover of the equipment, and then press
the [OK] button.
(6) "Serial Number Setting completed" is displayed.
(7) Turn the power OFF.
(8) Turn the power ON while pressing the [5] and [9] buttons simultaneously.
(9) Enter the password, and then press the [OK] button.
(If the password is not set for Service, press the [ENTER] button without entering anything.)
(10) Select "1. Backup SRAM Data to USB", and then press the [START] button.
(11) Enter a password (max. 15 characters) set for the backup data.
(12) "Backup Successfully done Restore the MFP" is displayed on the LCD screen when the backup
has been properly completed.
e-STUDIO2555C/3055C/3555C/4555C/5055C
BACKUP FUNCTION
E.g.: When backup was performed at 13:59 on
October 1st, 2010.
T212_CUK911379_2010-10-01_13-59
[2]
[1]
Fig.12-1
© 2012-2013 TOSHIBA TEC CORPORATION All rights reserved
12 - 2
Remark