Image Dimensional Adjustment In The Copy/Printer/Fax Function - Toshiba e-STUDIO 2555C Service Manual

Multifunctional digital color systems

Hide thumbs Also See for e-STUDIO 2555C:

Image dimensional adjustment in the copy/printer/fax function

[ 1 ] Reproduction ratio adjustment of primary scanning direction

The reproduction ratio in the primary scanning direction of the printed image can be adjusted as

*1: This adjustment is not available for the printer function when the resolution of the image is 600 x

Make a test copy and compare the image obtained with the current settings; if necessary, make

adjustments according to the following procedure:

Since the reproduction ratio may vary due to expansion and contraction of the paper immediately

after the image is printed out, it is recommended to measure its dimension after at least 3

minutes have passed.

This adjustment may cause image troubles such as moire, disappearance or breaking of thin

lines on the printed image. Therefore check if there is no such image trouble while you are

performing the adjustment.

While pressing [0] and [5] simultaneously, turn the power ON.

Key in a code and press the [START] button.

Key in the adjustment value. (To correct a value, press the [CLEAR] button.)

Press the [OK] or [INTERRUPT] button to store the value. -> The equipment goes back to the

ready state.

Make a test copy and check the image copied. To check the printed image, turn off the power

and then back on, and then print the image. If the image is not in the desired reproduction ratio,

repeat steps (2) to (4).

e-STUDIO2555C/3055C/3555C/4555C/5055C

SETTING / ADJUSTMENT

The larger the value is, the larger the reproduction ratio in the primary

scanning direction becomes.

Acceptable values: 0 to 255 (Default: 128)

The larger the value is, the larger the reproduction ratio in the primary

scanning direction becomes.

Acceptable values: 128 to 255 (Default: 128)

Show Quick Links