Toshiba e-STUDIO 2555C Service Manual page 1084

Sub
05/08 Mode Element
element
05 Adjustmen Process Transfer Setting value of 2nd
t mode transfer restraining
current 2
05 Adjustmen Process Transfer Enforced toner supply
t mode / Number of time of
cleaning at the end of
fusing-wait period
05 Adjustmen Process Transfer Enforced toner supply
t mode / Number of time of
cleaning at the end of
fusing-wait period
05 Adjustmen Scanner Scanner Image location
t mode adjustment
05 Adjustmen Scanner Scanner Image location
t mode adjustment
05 Adjustmen Scanner Scanner Reproduction ratio
t mode adjustment
05 Adjustmen Scanner Scanner
t mode
05 Adjustmen Scanner Scanner Shading position
t mode adjustment
05 Adjustmen Scanner Scanner Shading position
t mode adjustment
05 Adjustmen Scanner RADF Adjustment of RADF
t mode paper alignment
Item Subitem Code
2964
2966
2966
3030
3031
3032
3033
3034
3035
3040
Sub- Default Acceptable
Details
code value value
1 Decelerating 4 -50-25
0 Normal speed / High 2 0-7
speed
1 Decelerating 2 0-7
Primary scanning 113 0-255
direction
Secondary scanning 130 67-189
direction
Adj. secondary 128 0-255
scan.direction
Distortion mode - -
Original glass 117 71-186
RADF 133 71-186
Single sided original 12 0-30
25
RAM Contents
(Unit: μA)
M
M 0: Once 1: Twice 2: 3 times 3: 5 times 4: 7 times 5:
10 times 6: 12 times 7: 15 times
M 0: Once 1: Twice 2: 3 times 3: 5 times 4: 7 times 5:
10 times 6: 12 times 7: 15 times
SYS When the value increases by "1", the image shifts by
approx. 0.0423 mm toward the front side of the paper.
SYS When the value increases by "1", the image shifts by
approx. 0.08192 mm toward the trailing edge of the
paper.
*If the value of 05-3031 is changed, the values of 05-
3046 and 05-3047 are also changed. However, the
value of 05-3031 is not changed even if the values of
05-3046 and 05-3047 are changed. When the value of
05-3031 is changed, confirm the values of 05-3046 and
05-3047. When adjusting 05-3031, 05-3046, and 05-
3047, adjust 05-3031 first, then adjust 05-3046 and 05-
3047.
SYS When the value increases by "1", the reproduction ratio
in the secondary scanning direction (vertical to paper
feeding direction) increases by approx. 0.017%.
SYS Moves carriages to the adjustment position.
SYS 0.08192mm/step
SYS 0.08333 mm/step
SYS When the value increases by "1", the aligning amount
increases by approx. 0.4 mm.
Proce Servic
dure e UI
4
4
4
1 Yes
1 Yes
1 Yes
6 Yes
1
1
1