Toshiba e-STUDIO 2555C Service Manual page 629

[E721] Jam not reaching the read sensor
Classification
RADF jam
Phenomenon of paper jamming
All
Parts to be replaced
Reading start guide of the
RADF
Paper guide of the RADF
Read sensor
RADF board
Registration roller
Read roller
[E722] Jam not reaching the original exit/reverse sensor (during scanning)
Classification
RADF jam
Check item
Read roller
Original exit/reverse sensor
RADF board
Parts to be replaced
Original exit/reverse sensor
RADF board
Read roller
© 2012-2013 TOSHIBA TEC CORPORATION All rights reserved
Jam not reaching the read sensor
Check item
Registration Clean the registration roller and the read roller if
sensor they are stained.
Read roller
Read sensor • Sensor check (Perform the input check: 03-
[FAX] ON[7]/[G])
• Connector check (CN75, J94)
• Harness check
RADF board • Board check
• Connector check (CN75)
• Harness check
Replace it if it is worn out.
Replace it if it is worn out.
Jam not reaching the original exit/reverse sensor (during scanning)
Clean the read roller if it is stained.
• Sensor check (Perform the input check: 03-[FAX] ON[7]/[E])
• Connector check (CN75, J93)
• Harness check
• Board check
• Connector check (CN75)
• Harness check
Replace it if it is worn out.
8 - 73
Error content
Measures
Remark
Error content
Measures
Remark
e-STUDIO2555C/3055C/3555C/4555C/5055C
ERROR CODE AND TROUBLESHOOTING
8