Automatic Duplexing Unit (Adu) - Toshiba e-STUDIO 2555C Service Manual

4.11 Automatic Duplexing Unit (ADU)

4.11.1

Automatic duplexing unit (ADU)
(1) Disconnect the 3 connectors [1], and release
the harness from harness clamp.
(2) Remove 1 screw and take off the wire end
bracket [1] by holding up the automatic
duplexing unit and sliding the bracket toward
the rear side.
Notes:
When removing/attaching the wire end
bracket, be sure to hold up the automatic
duplexing unit so that the opening angle
becomes smaller.
Notes:
After removing the wire end bracket, hang it
on the hook of the frame so that the spring of
the wire does not come off.
© 2012-2013 TOSHIBA TEC CORPORATION All rights reserved
Fig. 4-531
Fig. 4-532
Fig. 4-533
e-STUDIO2555C/3055C/3555C/4555C/5055C
4 - 191
DISASSEMBLY AND REPLACEMENT
4