Scan Motor (M1) - Toshiba e-STUDIO 2555C Service Manual

(4) Remove the exposure lamp [1].
Notes:
When installing, make sure that the exposure
lamp is placed in the correct orientation.
4.3.7

Scan motor (M1)

(1) Remove the top rear cover.
 P. 4-5 "4.1.14 Top rear cover"
(2) Remove the rear top cover.
 P. 4-5 "4.1.13 Rear top cover"
(3) Remove 2 screws and disconnect the 1
connector [1], and take off the scan motor
assembly [2].
Notes:
When installing the scan motor, use the belt
tension jig.
 P. 6-80 "6.6.3 Belt tension adjustment of
the Scan motor"
(4) Remove 2 screws and take off the scan
motor [1].
e-STUDIO2555C/3055C/3555C/4555C/5055C
DISASSEMBLY AND REPLACEMENT
© 2012-2013 TOSHIBA TEC CORPORATION All rights reserved
4 - 16
Fig. 4-41
Fig. 4-42
Fig. 4-43