Toshiba e-STUDIO 2555C Service Manual page 619

[E013] Jam not reaching transport sensor after paper alignment at the registration roller
Classification
Other paper jam
Phenomenon of paper jamming
Paper stop jam at Registration
roller
Parts to be replaced
Rollers
Developer unit
[E030] Power-ON jam
Classification
Other paper jam
Check item
Sensor in the jamming area
LGC board
Parts to be replaced
Sensor in the jamming area
LGC board
Relation between the jamming area and the corresponding sensors/covers.
(If a jam is occurring in the ADU, LCF or PFP, check the board in each unit.)
Jamming area Cover
Registration area Jam access
cover
Exit area Fuser cover
ADU ADU
Bypass feed unit Side cover
LCF LCF side cover
© 2012-2013 TOSHIBA TEC CORPORATION All rights reserved
Jam not reaching transport sensor after paper alignment at the
registration roller
Check item
Drawer Check if any damage is at the leading edge.
Check if paper is folded at the leading edge.
Drive unit, • Drive unit check
Rollers • Gear check
• Roller check
Developer Replace the Developer unit.
unit
Power-ON jam
• Sensor check (Refer to the table below)
• Connector check
• Harness check
• Board check
• Connector check
• Harness check
Refer to the table below.
Sensor
Registration sensor
Paper clinging detection
sensor
Registration pass sensor
Feed sensor
Exit sensor
ADU entrance sensor
ADU exit sensor
2nd drawer feed sensor
LCF feed sensor
8 - 63
Error content
Measures
Remark
Error content
Measures
Remark
Test Mode/Input check
03-[ALL]OFF/[9]/[A]
03-[ALL]OFF/[9]/[E]
03-[ALL]OFF/[9]/[F]
03-[ALL]OFF/[9]/[B]
03-[ALL]OFF/[9]/[C]
03-[ALL]OFF/[9]/[G]
03-[ALL]OFF/[9]/[H]
03-[FAX]ON/[4]/[D]
03-[COPY]ON/[9]/[F]
e-STUDIO2555C/3055C/3555C/4555C/5055C
ERROR CODE AND TROUBLESHOOTING
8