6.8
Paper Feeding System
6.8.1
Adjusting the clearance of the paper and side guides
If the clearance between the paper and the side guides is too wide, it can be adjusted to between 0 and
1 mm using the following procedure (the clearance between the paper and the guides is 1 to 2 mm
including both front and rear sides).
<Procedure>
(1)
Take out the drawer.
(2)
Move the side guide[1]. Loosen 2 screws.
(3)
Move the side guide adjustment piece[1] to
the front and tighten the screws (by 0.5 mm).
e-STUDIO2555C/3055C/3555C/4555C/5055C
SETTING / ADJUSTMENT
© 2012-2013 TOSHIBA TEC CORPORATION All rights reserved
6 - 82
Fig.6-28
Fig.6-29
Fig.6-30