Toshiba e-STUDIO 2555C Service Manual page 737

Check Item
Tray safety switch (SW2)
Stack tray shift motor (M2)
Replacement part
Tray safety switch (SW2)
Stack tray shift motor (M2)
Finisher control PC board
[CDE0] Paddle motor abnormality
* You receive a [CDE0] error when the [ED15] error occurs three times in succession or during the
initial operation.
Classification
Finisher related service call
MJ-1107
Check Item
Paddle
Paddle motor
Replacement part
Paddle motor
Finisher control PC board
MJ-1108
Check Item
Paddle
Paddle motor (M8)
Replacement part
Paddle motor (M8)
Finisher control PC board
© 2012-2013 TOSHIBA TEC CORPORATION All rights reserved
Check the connectors and harnesses between the tray safety
switch (SW2) and the connector J110 on the finisher controller
PC board.
Check the connectors and harnesses between the stack tray
shift motor (M2) and the connector J114 on the finisher
controller PC board.
Paddle motor abnormality: The paddle motor is not rotating or
the paddle is not rotating normally.
Rotate the paddle.
Fix any mechanical problem.
Check if the connector (CN22) on the finisher controller PC
board is disconnected from the paddle motor (M3) and the
harnesses are open circuited. Correct if so.
IRotate the paddle.
Fix any mechanical problem.
Check the connectors and harnesses between the paddle
motor (M8) and the finisher control PC board (CN6).
8 - 181
Measure
Measure
Contents
Measure
Measure
Measure
Measure
e-STUDIO2555C/3055C/3555C/4555C/5055C
ERROR CODE AND TROUBLESHOOTING
8