Toshiba e-STUDIO 2555C Service Manual page 441

[C] Secondary scanning data writing start position
Performing the code 05-4402 covers this adjustment for all paper sources.
The adjustment for each paper source is also available.
For all paper sources
Code Paper size
4402 A3/LD
For each paper source
Order for
adjustmen Paper source
t
1 1st drawer
2 2nd drawer
3 3rd drawer
4 4th drawer
5 Bypass feed
6
Duplexing
While pressing [0] and [5] simultaneously, turn the power ON. → (Adjustment Mode)
(1)
Press [98] ([3] for duplexing) → [FAX]. (A grid pattern with 10 mm pitch is printed out.)
(2)
(3) Measure the distance C from the leading edge of the paper to the 6th line of the grid pattern.
* Normally, the 1st line of the grid pattern is not printed.
* At the duplexing, measure it on the top side of the grid pattern.
(4) Check if the distance C is within 52±0.5 mm.
(5) If not, use the following procedure to change values and measure the distance C again.
<Procedure>
(Adjustment Mode) → (Key in the code shown above) → [START]
→ (Key in an acceptable value shown above)
→ [OK] or [INTERRUPT] (Stored in memory)
→ "100% A" is displayed
→ Press [98] ([3] for duplexing)
→ [FAX] → (A grid pattern is printed out.)
* The larger the adjustment value is, the longer the distance C becomes (approx. 0.10 mm/
step).
© 2012-2013 TOSHIBA TEC CORPORATION All rights reserved
Acceptable value Remarks
0 to 200 Performs the adjustment for all paper sources.
Code Paper size
4058 A4/LT
4059 A3/LD
4060 A4/LT
4560 A4/LT
4061 A4/LT
4062 A3/LD
6 - 15
Acceptabl
Remarks
e value
0 to 100
0 to 100
0 to 100
0 to 100
0 to 100
Paper fed from the 2nd
0 to 100
drawer
e-STUDIO2555C/3055C/3555C/4555C/5055C
SETTING / ADJUSTMENT
6