Toshiba e-STUDIO 2555C Service Manual page 391

This operation requires only a few seconds; however, you must create the partition in the HDD in the
3C mode (Format HDD) and reinstall the HDD data in the 49 mode to make the HDD reusable.
When "1" is selected and then [START] button is pressed, the menu below appears.
To start, press the [START] button.
HDD Assist Mode
Current HDD type: ADI HDD
Select number (1-2) and press START key
1. Revert factory initial status HDD
=>
2. Remove key
When the operation is finished, the result appears on the menu.
HDD Assist Mode
Current HDD type: ADI HDD
Select number (1-2) and press START key
1. Revert factory initial status HDD
=>
2. Remove key
Data in the HDD has been complately erased.
Press SoftPower Key to Switch Off
Note:
If the equipment is started in the normal mode with this condition, an HDD mounting error occurs.
[B] 2. Remove Key
Select this to reuse the ADI-HDD as well as the equipment.
When this item is selected, image data in the HDD are deleted.
This operation requires approx. 20 minutes since the partition must be rebuilt.
© 2012-2013 TOSHIBA TEC CORPORATION All rights reserved
System Firmware Version
Update Mode
Confirmation Screen
Are you sure ???
Press START to continue
Press STOP to cancel
Fig.5-10
System Firmware Version
Update Mode
Fig.5-11
5 - 25
: xxxx(x.x.x.x)
: 4c Mode
: xxxx(x.x.x.x)
: 4c Mode
e-STUDIO2555C/3055C/3555C/4555C/5055C
SELF-DIAGNOSTIC MODE
5