St Drawer Paper Width Detection Switch (Sw6 And 1St Drawer Paper Length Detection Switch (Sw7) - Toshiba e-STUDIO 2555C Service Manual

(6) Disconnect the 1 connector [1], and remove
the 2nd drawer empty sensor [2].
Disconnect the 1 connector [3], and remove
the 2nd drawer tray-up sensor [4].
Notes:
When installing connectors, connect the
white connector to the 2nd drawer empty
sensor [2], and the yellow connector to the
2nd drawer tray-up sensor [4].
4.5.28 1st drawer paper width detection switch (SW6) and 1st drawer
paper length detection switch (SW7)
(1) Remove the high-voltage transformer.
 P. 9-9 "9.1.8 High-voltage transformer
(HVT)"
(2) Remove 1 spring [1] and disconnect the 2
connectors [2].
Notes:
Connect the yellow harness connector to the
left side.
(3) Release the latch, and remove the switch
holder [3].
(4) Release the latch, and remove the 1st
drawer paper width detection switch [1] and
1st drawer paper length detection switch [2].
© 2012-2013 TOSHIBA TEC CORPORATION All rights reserved
Fig. 4-185
Fig. 4-186
Fig. 4-187
e-STUDIO2555C/3055C/3555C/4555C/5055C
4 - 65
DISASSEMBLY AND REPLACEMENT
4