Notes:
When installing, align the duct [1] in the front
side of the reverse unit with the projection
[2].
4.10.2
Paper exit unit
(1)
Remove the fuser unit.
P. 4-147 "4.9.1 Fuser unit"
(2)
Remove the reverse unit.
P. 4-181 "4.10.1 Reverse unit"
(3)
Remove 3 screws and take off the paper exit
unit [1].
Notes:
When installing the paper exit guide, align
the protrusion on the rear of the bottom of
the screw hole with the frame hole, and fit
the drive gear shaft into the bearing.
© 2012-2013 TOSHIBA TEC CORPORATION All rights reserved
Fig. 4-510
Fig. 4-511
Fig. 4-512
e-STUDIO2555C/3055C/3555C/4555C/5055C
4 - 183
DISASSEMBLY AND REPLACEMENT
4