Toshiba e-STUDIO 2555C Service Manual page 834

Ste
Cause/Section
p
Transfer belt 7 Deformation or damage of the
transfer belt or stains on the
transfer belt.
8 Are the gears on the transfer belt
side loosen, damaged or
deformed?
9 Stain or damage of the drive
roller
10 Does the rib of the transfer belt
overlap the collar on both edge
of the drive roller?
11 Is the belt edge damaged or
stained?
12 Peeling of the cleaning blade
(Large driving load)
13 Is the transfer belt unit installed
normally?
(Is the unit properly grounded?)
High-voltage 14 Check the connection of the
transformer high-voltage supply terminal of
the 1st or 2nd transfer rollers.
e-STUDIO2555C/3055C/3555C/4555C/5055C
ERROR CODE AND TROUBLESHOOTING
Check Item
Clean or replace the transfer
belt.
Tighten the screws if they
loosen, or replace the gears.
Clean or replace the drive
roller.
Adjust the position of the
transfer belt.
Clean or replace the transfer
belt.
Replace the cleaning blade.
Check and correct the
installing.
Correct or replace the terminal
if it is loosened or damaged.
© 2012-2013 TOSHIBA TEC CORPORATION All rights reserved
8 - 278
Measure Remark