Registration Roller (Rubber) - Toshiba e-STUDIO 2555C Service Manual

(3) Open the side cover.
(4) Remove the clip [1], slide the roller shaft
toward the rear side, remove the front shaft,
and then take off the registration roller shaft
[2].
(5) Remove the 2 bushings [1], 1 E-ring [2], 1
gear [3] and pin [4].
4.5.9

Registration roller (Rubber)

(1) Remove 2 screws (front/rear). While
compressing the spring, slide the holder in
the direction indicated by the arrow to align it
with the notch. Then take off the holder and
the spring.
e-STUDIO2555C/3055C/3555C/4555C/5055C
DISASSEMBLY AND REPLACEMENT
Fig. 4-128
Fig. 4-129
Fig. 4-130
© 2012-2013 TOSHIBA TEC CORPORATION All rights reserved
4 - 46