Fuser Unit / Paper Exit Section - Toshiba e-STUDIO 2555C Service Manual

3.16 Fuser unit / Paper exit section

3.16.1 General Description
Toner is fused by applying heat and pressure on the transferred image on the paper which is trans-
ported to the fuser unit. The paper is then transported to the inner tray, paper exiting options or ADU.
The fuser unit consists of the IH coil, fuser belt, pressure roller, separation fingers, separation guide,
thermistors, thermostats, etc.
The fuser belt in the fuser unit is driven by the fuser motor.
[14]
[9]
[12]
[13]
[2]
[10]
[11]
[1] Fuser belt
[2] Fuser belt thermostat
[3] Fuser belt center thermistor
[4] Fuser belt edge thermistor
[5] Fuser belt side thermistor
[6] Pressure roller
[7] Separation finger
[8] Exit sensor
[9] Separation guide
[10] Fuser belt rotation detection sensor
[11] Pressure roller contact/release detection sensor
[12] Fuser belt pad
[13] Rotation detection plate
[14] Fuser belt drive shaft
© 2012-2013 TOSHIBA TEC CORPORATION All rights reserved
Fig. 3-45
e-STUDIO2555C/3055C/3555C/4555C/5055C
3 - 77
[8]
[7]
[3] ,[4],[5]
[12]
[6]
[1]
OUTLINE OF THE MACHINE
3