Classification
Paper jam in finisher section
MJ-1107
Check item
Stapler
Finisher controller PC board
Parts to be replaced
Stapler
Finisher controller PC board
MJ-1108
Check item
Stapler
Finisher controller PC board
Parts to be replaced
Stapler
Finisher controller PC board
© 2012-2013 TOSHIBA TEC CORPORATION All rights reserved
Error content
Stapling jam
Measures
•
Check if there is any paper in the finisher or on the transport
path of the equipment or on the finishing tray. Remove it if there
is
•
Is the jam cleared by taking off the staple cartridge from the
finisher and removing the staple sheet slid from the staple
case?(S11)
•
If the actuator of the stapler safety sensor (S11) does not move
smoothly, remove its clip from the side and then reattach it.
•
Connector check (CN2)
•
Harness check
•
Board check
•
Connector check (CN2)
•
Harness check
Remark
Measures
•
Check if there is any paper in the finisher or on the transport
path of the equipment or on the finishing tray. Remove it if there
is
•
Is the jam cleared by taking off the staple cartridge from the
finisher and removing the staple sheet slid from the staple case?
•
If the actuator of the stapler safety sensor (S11) does not move
smoothly, remove its clip from the side and then reattach it.
•
Connector check
•
Harness check
•
Board check
•
Connector check (CN19)
•
Harness check
Remark
8 - 97
e-STUDIO2555C/3055C/3555C/4555C/5055C
ERROR CODE AND TROUBLESHOOTING
8