Toshiba e-STUDIO 2555C Service Manual page 199

(5) Release the latch, and remove the sensor
holder [1] from the front side by sliding it
toward the left side.
Notes:
When installing, pass the connector through
the hole, and fix it using the sensor holder
projection [1] and latch [2].
(6) Disconnect the 1 connector [1], and remove
the 1st drawer empty sensor [2].
Disconnect the 1 connector [3], and remove
the 1st drawer tray-up sensor [4].
Notes:
When installing connectors, connect the
white connector to the 1st drawer empty
sensor [2], and the yellow connector to the
1st drawer tray-up sensor [4].
© 2012-2013 TOSHIBA TEC CORPORATION All rights reserved
Fig. 4-179
Fig. 4-180
Fig. 4-181
e-STUDIO2555C/3055C/3555C/4555C/5055C
4 - 63
DISASSEMBLY AND REPLACEMENT
4