Skew (Slantwise Copying) - Toshiba e-STUDIO 2555C Service Manual

8.5.14

Skew (slantwise copying)

Cause/Section Step
Drawer/LCF 1
2
3
4
Paper feed 5
roller
Rollers 6
2nd transfer 7
roller
Aligning 8
amount
Registration 9
roller
Registration 10
guide
2nd transfer 11
front guide
RADF 12
e-STUDIO2555C/3055C/3555C/4555C/5055C
ERROR CODE AND TROUBLESHOOTING
Fig.8-18
Check item
Is the drawer or LCF properly
installed?
Is too much paper loaded in the
drawer or LCF?
Is the paper corner folded?
Are the drawer or LCF side guides
properly set?
Is the surface of paper feed roller
dirty?
Is each roller improperly fixed to the
shaft?
Install the roller by reversing its back
and front sides.
Is the aligning amount proper?
Is the registration roller spring
removed?
Is the registration guide improperly
installed?
Is the 2nd transfer front guide
installed properly?
Is the RADF installed and adjusted
properly?
8 - 300
Measures
Reinstall the drawer or LCF properly.
Reload paper within the acceptable
range of paper weight.
<Acceptable paper weight>
1st, 2nd, 3rd and 4th drawers: 60.5
mm
LCF: 137.8 mm x 2 places
Change the paper direction and
reinsert it.
Adjust the side guides.
Clean the roller surface with alcohol,
or replace the roller.
Check E-rings, pins and clips.
Output and check the printed image.
Increase or decrease the aligning
amount.
Mount the spring correctly. Clean the
roller if it is dirty.
Correct it.
Correct it.
Reinstall and readjust it.
© 2012-2013 TOSHIBA TEC CORPORATION All rights reserved