Toshiba e-STUDIO 2555C Service Manual page 667

Parts to be replaced
Front alignment plate home
position sensor
Front alignment motor
Finisher controller PC board
MJ-1108
Check item
Front alignment plate
Front alignment plate home
position sensor
Front alignment motor
Parts to be replaced
Front alignment plate home
position sensor
Front alignment motor
Finisher controller PC board
[ED14] Rear alignment plate home position error
Classification
Other paper jam
MJ-1107
Check item
Rear alignment plate
Rear alignment plate home
position sensor
Rear alignment motor
Parts to be replaced
Rear alignment plate home
position sensor
Rear alignment motor
© 2012-2013 TOSHIBA TEC CORPORATION All rights reserved
Remark
Measures
Move the front alignment plate.
Fix any mechanical problem.
Check if there is a disconnection of the connector, incorrect
installation or breakage of the front alignment plate home position
sensor (S7). If there is, reinstall the sensor correctly or replace it.
Check if the connector (CN18) on the finisher controller PC board is
disconnected from the front alignment plate home position sensor
(S7) and the harnesses are open circuited. Correct if so.
Check if the connector (CN17) on the finisher controller PC board is
disconnected from the front alignment motor (M5) and the
harnesses are open circuited. Correct if so.
Remark
Error content
Rear alignment plate home position error
Measures
Move the rear alignment plate.
Fix any mechanical problem.
Check if there is a disconnection of the connector, incorrect
installation or breakage of the rear alignment plate home position
sensor (S8). If there is, reinstall the sensor correctly or replace it.
Check if the connector (CN11) on the finisher controller PC board is
disconnected from the rear alignment plate home position sensor
(S8) and the harnesses are open circuited. Correct if so.
Check if the connector (CN10) on the finisher controller PC board is
disconnected from the rear alignment motor (M10) and the
harnesses are open circuited. Correct if so.
Remark
8 - 111
e-STUDIO2555C/3055C/3555C/4555C/5055C
ERROR CODE AND TROUBLESHOOTING
8