Toshiba e-STUDIO 2555C Service Manual page 620

Jamming area
PFP PFP side cover PFP upper drawer feed sensor 03-[FAX]ON/[0]/[C]
Bridge unit Bridge unit
Finisher Finisher door
[E061]Incorrect paper size setting for 1st drawer
[E062]Incorrect paper size setting for 2nd drawer
[E063]Incorrect paper size setting for PFP upper drawer
[E064]Incorrect paper size setting for PFP lower drawer
[E065]Incorrect paper size setting for bypass tray
If any paper remains in the equipment or drawer, remove it. Match the paper size of the drawer
setting and the one in the drawer.
* Paper size detection is performed at the first sheet of paper when the drawer is opened or closed, or
when the power of the equipment is turned ON.
[E090]Image data delay jam
Classification
Other paper jam
Check item
Other
SYS board
LGC board
HDD
Replace parts
SYS board
LGC board
HDD
Main memory
[E091] Motor on time-out jam
Classification
Other paper jam
e-STUDIO2555C/3055C/3555C/4555C/5055C
ERROR CODE AND TROUBLESHOOTING
Cover
PFP lower drawer feed sensor 03-[FAX]ON/[0]/[D]
Bridge unit transport sensor-1
(Entrance sensor)
Bridge unit transport sensor-2
(Exit sensor)
Sensors in the finisher
Image data to be printed cannot be prepared.
• Remove the paper remained in front of the registration
sensor)
• Check if the error is cleared by turning the power OFF and
then back ON.
• Connector check
• Main memory check
• Board check
• Connector check
• Board check
• Connector check
• HDD check
The equipment does not operate normally because
abnormality occurred on an interface between the SYS board
and engine firmware.
8 - 64
Sensor
03-[ALL]OFF/[0]/[A]
03-[ALL]OFF/[0]/[B]
Error item
Measures
Remarks
Error item
© 2012-2013 TOSHIBA TEC CORPORATION All rights reserved
Test Mode/Input check
-