•
Before installing the LED print head unit,
mount the link alone.
[1] LED print head contact/release lever
link
[2] Lever
•
Make sure that the duct in the rear side is
securely positioned without any
clearance.
•
When installing the LED print head unit,
push both sides [1] and then the center
part [2] of the head inside. Then, make
sure that the head is securely installed.
•
After the link has been installed, check
the contact/release operations.
© 2012-2013 TOSHIBA TEC CORPORATION All rights reserved
Fig. 4-83
Fig. 4-84
Fig. 4-85
e-STUDIO2555C/3055C/3555C/4555C/5055C
4 - 31
DISASSEMBLY AND REPLACEMENT
4