Carriage Wire, Carriage-2 - Toshiba e-STUDIO 2555C Service Manual

(6) Rotate carriage-1 [1] in the direction shown
in the figure, while trying not to touch the
mirror. Then remove carriage-1 [1].
Notes:
Follow the procedure below to connect the
exposure lamp harness.
1. Push carriage-1 and -2 to the leftmost
side and fix carriage-1.
2. Securely install the exposure lamp
harness on the cable guide and SYS
board.
3. After connecting the exposure lamp
harness, move carriage-1 to the leftmost
side and check the lamp harness for any
twists.
4.3.10

Carriage wire, carriage-2

[A] Carriage wire, carriage-2
(1) Remove carriage-1.
 P. 4-18 "4.3.9 Carriage-1"
(2) Move carriage-2 to the center.
(3) Attach the wire holder jig [2] to the wire
pulley [1] to prevent the wire from coming
loose.
© 2012-2013 TOSHIBA TEC CORPORATION All rights reserved
Fig. 4-50
Fig. 4-51
Fig. 4-52
e-STUDIO2555C/3055C/3555C/4555C/5055C
4 - 19
DISASSEMBLY AND REPLACEMENT
4