Toshiba e-STUDIO 2555C Service Manual page 611

Parts to be replaced
Feed roller
Separation roller
Pickup roller
PFP transport roller
[E510] ADU transport stop jam
Classification
Paper transport jam
Check item
Reverse sensor
ADU entrance sensor
Reverse motor
LGC board
ADU board
Reverse roller
Upper exit roller
Parts to be replaced
Reverse sensor
ADU entrance sensor
Reverse motor
LGC board
ADU board
Reverse roller
Upper exit roller
© 2012-2013 TOSHIBA TEC CORPORATION All rights reserved
Replace it if it is worn out.
Replace it if it is worn out.
Replace it if it is worn out.
Replace it if it is worn out.
ADU transport stop jam
• Sensor check (Perform the input check: 03-[ALL]OFF/[9]/[D])
• Connector check (J1064, J1104)
• Harness check
• Sensor check (Perform the input check: 03-[ALL]OFF/[9]/[G])
• Connector check (J1067, CN421)
• Harness check
• Motor check (Perform the output check: 03-121/171)
• Connector check (J1001, J1118, CN351)
• Harness check
• Connector check (CN353, CN390)
• Harness check
• Board check
• Connector check (CN420, CN421, CN422, J1064)
• Harness check
• Board check
Roller check (attrition, deformation, deterioration)
Roller check (attrition, deformation, deterioration)
8 - 55
Remark
Error content
Measures
Remark
e-STUDIO2555C/3055C/3555C/4555C/5055C
ERROR CODE AND TROUBLESHOOTING
8