Toshiba e-STUDIO 2555C Service Manual page 654

[EA60] Early arrival jam
Classification
Paper jam in finisher section
MJ-1036
Probable cause
Entrance path sensor (S19)
abnormality
Faulty cables and connectors
Finisher control PC board
(FIN) abnormality
MJ-1107
Check item
Entrance sensor
Finisher controller PC board
Parts to be replaced
Entrance sensor
Finisher controller PC board
MJ-1108
Check item
Finisher
Feeding sensor (S22)
Interface control PC board (I/F) •
Parts to be replaced
Feeding sensor (S22)
Interface control PC board (I/F)
e-STUDIO2555C/3055C/3555C/4555C/5055C
ERROR CODE AND TROUBLESHOOTING
Error content
Early arrival jam
Checking and measures
Measure the voltage on TP86 on the finisher control PC board
(FIN). Then check that the measured voltage is 1V or lower when
not shielded and within the range of 3.3V±5% when shielded. If the
voltage does not fall within the range mentioned, replace the
sensor.
Check if the electrical continuity between the connector terminals is
normal. If electricity is not conducted, replace the connector.
(Finisher control PC board (FIN): CN22)
If the error still occurs after replacing the sensor and the connector,
exchange the finisher control PC board (FIN).
Measures
• Sensor check(S1)
• Connector check (CN7)
• Harness check
• Board check
• Connector check (CN7)
• Harness check
Remark
Measures
Check if there is any paper in the finisher or on the transport path of
the equipment and remove it if there is.
• Sensor check(S22)
• Connector check (CN8)
• Harness check
Board check
• Connector check (CN8)
• Harness check
Remark
© 2012-2013 TOSHIBA TEC CORPORATION All rights reserved
8 - 98