Toshiba e-STUDIO 2555C Service Manual page 565

Error code Classification
E910 Finisher jam
(Bridge unit)
E920
E930
E940
E950 Job separator jam
E951
E9F0 Finisher jam
(Puncher unit)
EA10 Finisher jam
(Finisher section)
EA20
EA21
EA22
© 2012-2013 TOSHIBA TEC CORPORATION All rights reserved
Contents
Jam at the bridge unit transport sensor 1: The
paper does not reach the bridge unit transport
sensor 1 after it has passed the exit sensor.
Stop jam at the bridge unit transport sensor 1:
The trailing edge of the paper does not pass
the bridge unit transport sensor 1 after its
leading edge has reached the sensor.
Jam at the bridge unit transport sensor 2: The
trailing edge of the paper does not reach the
bridge unit transport sensor 2 after its leading
edge has reached the bridge unit transport
sensor 1.
Stop jam at the bridge unit transport sensor 2:
The trailing edge of the paper does not pass
the bridge unit transport sensor 2 after its
leading edge has reached the bridge unit
transport sensor 2.
Jam not reaching the job separator transport
sensor: The paper has passed through the exit
sensor does not reach the job separator
transport sensor.
Stop jam at the job separator transport sensor:
The trailing edge of the paper does not pass
the job separator transport sensor.
Punching jam: Jam occurred at the HP
detection of punch motor. [MJ-1036]
Punching jam: Punching is not performed
properly.
[MJ-1107/1108 (when MJ-6104 is installed)]
1st transport motor (M8) fault/ 2nd transport
motor (M4) fault [MJ-1036]
Paper transport delay jam: The paper which
has passed the bridge unit does not reach the
entrance sensor.[MJ-1107]
The paper which has passed the bridge unit
does not reach the entrance sensor. [MJ-1108]
1st transport motor (M8) fault/ 2nd transport
motor (M4) fault [MJ-1036]
Paper transport jam (transport sensor): Paper
being transported on the Finisher transport
path is stopped at the entrance sensor at 27.56
inches or longer. [MJ-1107/1108]
Paper size error jam: Paper does not reach the
sensor because the paper is shorter than spec.
[MJ-1107/1108]
Paper transport jam (Finisher paper punching
edge detection sensor): The paper position
sensor on the Finisher transport path detects
paper shorter than the acceptable paper size.
[MJ-1107/1108/MJ-6104]
8 - 9
Troubleshooting
P. 8-78
P. 8-78
P. 8-79
P. 8-79
P. 8-79
P. 8-79
P. 8-105
P. 8-81
P. 8-81
P. 8-82
P. 8-83
P. 8-84
P. 8-84
e-STUDIO2555C/3055C/3555C/4555C/5055C
ERROR CODE AND TROUBLESHOOTING
8