Led Emission Level Adjustment - Toshiba e-STUDIO 2555C Service Manual

6.3.17

LED emission level adjustment

The LED emission level in the BOX printing (black/binary), network FAX and e-mail FAX can be set.
The size of the dots can be adjusted.
<Adjustment Mode (05)>
Code Item to be adjusted
7330-0 LED emission level 0/4
7330-1 LED emission level 1/4
7330-2 LED emission level 2/4
7330-3 LED emission level 3/4
7330-4 LED emission level 4/4
Restart the equipment, and perform the printing job.
<Procedure>
The procedure is the same as that of  P. 6-54 "6.3.2 Gamma balance adjustment (Black Mode)".
Notes:
• The setting value must increase as the LED emission level number (0 to 4) becomes higher. Do
not increase this order when setting the values.
• Usually, LED emission level 4 / 4 is the most effective in the black mode.
• It is not applied to the images printed in the Black mode by the printer driver.
© 2012-2013 TOSHIBA TEC CORPORATION All rights reserved
Remarks
The smaller the value is, the smaller the LED
emission level of the primary scanning direction
becomes. Therefore, the smaller dots are reproduced
accordingly.
Acceptable values: 0 to 255
(Default: Level 0/4: 0, Level 1/4: 63, Level 2/4: 127,
Level 3/4: 191, Level 4/4: 255)
e-STUDIO2555C/3055C/3555C/4555C/5055C
6 - 65
SETTING / ADJUSTMENT
6