Ip Multicast Spoofing - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

IP Multicast Switching Commands

ip multicast spoofing

Enables or disables IGMP spoofing on the specified VLAN or on the system if no VLAN is specified.
ip multicast [vlan vid] spoofing [{enable | disable}]
no ip multicast [vlan vid] spoofing
Syntax Definitions
vid
enable
disable
Defaults
parameter
enable | disable
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
Use the no form of this command to remove an IGMP spoofing entry on the specified VLAN or on the
system and return to its default behavior.
•
If the IGMP spoofing is already enabled on the system, then the VLAN configuration will override the
system's configuration.
•
IGMP spoofing refers to replacing a client's MAC and IP address with the system's MAC and IP
address when proxying aggregated IGMP group membership information.
•
You can also restore the IGMP spoofing to its default (i.e., disabled) setting on the system if no VLAN
is specified, by using only ip multicast spoofing (e.g., ip multicast spoofing).
•
You can also restore the IGMP spoofing to its default (i.e., disabled) setting on the specified VLAN, by
using only ip multicast vlan vid spoofing (e.g., ip multicast vlan 2 spoofing).
Examples
-> ip multicast spoofing enable
-> ip multicast spoofing disable
-> ip multicast spoofing
-> ip multicast vlan 2 spoofing enable
-> ip multicast vlan 2 spoofing disable
-> ip multicast vlan 2 spoofing
-> no ip multicast vlan 2 spoofing
OmniSwitch 6250 CLI Reference Guide
VLAN on which to apply the configuration.
Enable IGMP spoofing.
Disable IGMP spoofing.
default
disable
November 2009 page 41-31