Show Policy Classify Ip Protocol - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

show policy classify ip protocol

Specifies an IP protocol for a hypothetical packet to show how the QoS software in the switch will handle
the packet.
show policy classify {l2 | l3 | multicast} [applied] ip protocol protocol
Syntax Definitions
l2
l3
multicast
applied
protocol
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
Use this command to determine if the switch will classify the traffic condition specified and match it to
a policy. By default the classifier only tests pending policies (policies that have not yet been applied).
Use the applied keyword to test only those policies that have been applied.
•
Use the qos apply command to activate policies.
Examples
-> show policy classify l3 ip protocol 6
See the output example given on
Release History
Release 6.6.1; command was introduced.
page 39-174
Uses the Layer 2 classifier for the hypothetical packet.
Uses the Layer 3 classifier for the hypothetical packet.
Uses the multicast IGMP classifier for the hypothetical packet.
Indicates that only applied policies should be examined.
The IP protocol number, for example, 6.
page 39-143 for more information about the potential screen display.
OmniSwitch CLI Reference Guide
QoS Policy Commands
November 2009