Show Policy Classify 802.1P - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

show policy classify 802.1p

Specifies a destination interface type for a hypothetical packet to show how the QoS software in the switch
will handle the packet.
show policy classify {l2 | l3 | multicast} [applied] 802.1p value
Syntax Definitions
l2
l3
multicast
applied
value
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
Use this command to determine if the switch will classify the traffic condition specified and match it to
a policy. By default the classifier only tests pending policies (policies that have not yet been applied).
Use the applied keyword to test only those policies that have been applied.
•
Use the qos apply command to activate saved policies.
Examples
-> show policy classify l2 802.1p 4
See the output example given on
Release History
Release 6.6.1; command was introduced.
Related Commands
qos apply
show policy classify
page 39-162
Uses the Layer 2 classifier for the hypothetical packet.
Uses the Layer 3 classifier for the hypothetical packet.
Uses the multicast IGMP classifier for the hypothetical packet.
Indicates that only applied policies should be examined.
The 802.1p value for the flow.
page 39-143 for more information about the potential screen display.
Applies configured QoS and policy settings to the current configuration.
Describes the base command.
OmniSwitch CLI Reference Guide
QoS Policy Commands
November 2009