Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual page 1689

QoS Policy Commands
-> show applied policy action
Action Name
action1
action2
-> show policy action action*
Action Name
action1
action2
output definitions
Action Name
From
Disp
Pri
Share
Max Bandwidth
Max Depth Bufs
Release History
Release 6.6.1; command was introduced.
Related Commands
policy action
OmniSwitch CLI Reference Guide
From Disp Pri
cli accept
cli accept
From Disp Pri
cli accept
cli accept
The name of the action, configured through the
mand.
Where the policy rule originated: cli indicates that the entry was config-
ured on the switch; ldap indicates the entry was configured through
PolicyView.
The disposition of the rule, either accept or deny.
The priority configured for the rule.
Whether or not the rule specifies that the queue should be shared.
The maximum bandwidth required by the rule.
Maximum depth (in Kbytes) of queues for traffic.
Creates a policy action. A QoS action is a particular set of bandwidth
and queue parameters that may be applied to a flow matching particular
QoS conditions.
November 2009
Bandwidth
Share Min Max Depth Bufs
No
No
Bandwidth
Share Min Max Depth Bufs
No
No
Max
Max
policy action com-
page 39-193