Cspal Continuous Delete Of Special Access Code For Ldm - NEC Univerge SV8500 Operation And Maintenance Manual

CSPAL:Continuous Delete of Special Access Code for LDM
1. Functional Outline
This command collectively lists/deletes the special access code data (LDM) assigned by the ASPAL command.
During activating this command, be sure not to run any other commands.
Note 1:
Note 2: To delete the data collectively, first readout the registered data by either of the following ways:
- Read out the registered data from the saved CSV file.
or
- Refresh the list of registered data on Data field specifying the range by GET TYPE.
When deleting the data collectively with CSV file, be sure to check the difference between the actual
assigned data and the data in CSV file beforehand.
In the case of failing in collective deletion, the command shows error message in STATUS field. Data
Note 3:
deletion is proceeded to the end even when error message appears.
To specify the range in GET TYPE, Connection Status Index (CI) cannot be selected. N (Normal), H
Note 4:
(Hooking), and B (Busy) are all listed.
In FCCS network, when changing the tenant table development by the system data (ASYDN SYS1
Note 5:
Index800 bit1), delete all the data assigned by ASPAL/ASPAN command on NCN and delete all the data
assigned by ASPAL command on each LN as well.
Refer to the table below for the required time to execute data deletion by CSPAL command. The running
Note 6:
time may vary depending on the network condition.
NUMBER OF DATA ENTRY
This command cannot be used on Hotel System.
Note 7:
RUNNING TIME
100 150 seconds
1,000 1,450 seconds
10,000 14,500 seconds
– 769 –
CHAPTER 7 Maintenance Commands