Network Settings; Browser Settings; Lan Cable Connection - Hitachi compute blade 500 series Getting Started Manual

Network settings

Set to the value, which suit your network environment, the IP address and
the subnet mask (the prefix, in the case of IPv6) of the system console. See
the documentation of your OS for how to setup.

Browser settings

Setup the client browser of the system console as described below.
• Disable any pop-up blockers.
Enabling of pop-ups may lead to unexpected behavior.
• Enable web cookies.
If web cookies are not enabled, you will not be able to login to the web
console of the management module.
See the documentation of your browser for how to setup.

LAN cable connection

Connect with a LAN cable between the system console and the management
module.
• When connecting the system unit to a management network:
Connect the LAN port of the system console and the management LAN
port #0(MGMT0) of the management module to the management
network.
Note: IP address of all the management modules shipped from the
factory is set for 192.168.0.1.
If you connect some management modules to a management network at
the same time without changing the IP address, a network failure due to
a duplicated IP address may occur.
When connecting to a management network, change the IP address and
connect the management modules one by one.
For details, see
• When not connecting to a management network:
Connect the LAN port of the system console to the management LAN port
#0(MGMT0) of the management module directly.
Management module configuration on page
Initial setup
Hitachi Compute Blade 500 Series Getting Started Guide
2-4.
2-3