Stop Condition - Fujitsu MB86R02 Jade-D Hardware Manual

Graphics controller

Hide thumbs Also See for MB86R02 Jade-D:

Table of Contents

MB86R02 'Jade-D' Hardware Manual V1.64

29.8.2 Stop condition

If a "0" is written to the MSS bit on master operation (MSS = 1), a stop condition occurs and the mode

changes to 'slave mode'. The following show the generation of a stop condition.

Writing a "0" to the MSS bit in interrupt status (MSS = 1 & BB = 1 & INT = 1 & AL = 0) on bus master.

Writing a "1" to the MSS bit in states other than the above is ignored.

Stop condition on the I

Changing the SDA line from "0" to "1" while the SCL line is "1" is called the 'stop condition'.

Stop condition