Fujitsu MB86R02 Jade-D Hardware Manual page 69

MB86R02 'Jade-D' Hardware Manual V1.64
DOUTR1_2 Digital RGB output1 R2
DOUTR1_3 Digital RGB output1 R3
DOUTR1_4 Digital RGB output1 R4
DOUTR1_5 Digital RGB output1 R5
DOUTR1_6 Digital RGB output1 R6
DOUTR1_7 Digital RGB output1 R7
I2C_SCL0
I2C_SDA0
I2C_SCL1
I2C_SDA1
I2S_SDO Serial Data Output
I2S_WS Word Select
I2S_ECLK I2S Clock Input (optional)
I2S_SCK I2S Clock Output
I2S_SDI Serial Data Input
INT_A_3
INT_A_2
INT_A_1
INT_A_0
TDO
TRACECLK
TDI
JTAG Selector (0 = Fujitsu TAP Controller, 1 =
JTAGSEL ARM Tap Controller)
RTCK Return test clock
Trace data used by the trace tool such as
TRACEDATA_0
RealView supplied by ARM Limited.
TRACECTL
XSRST ICE System reset
Trace data used by the trace tool such as
TRACEDATA_1 RealView supplied by ARM Limited.
Pull up to VDDE or pull down to VSS through high
resistance
Pull up to VDDE or pull down to VSS through high
resistance
Pull up to VDDE or pull down to VSS through high
resistance
Pull up to VDDE or pull down to VSS through high
resistance
Pull up to VDDE or pull down to VSS through high
resistance
Pull up to VDDE or pull down to VSS through high
resistance
Pull up to VDDE or pull down to VSS through high
resistance
Pull up to VDDE or pull down to VSS through high
resistance
Pull up to VDDE or pull down to VSS through high
resistance
Pull up to VDDE or pull down to VSS through high
resistance
Keep the pin open
Keep the pin open
Pull up to VDDE or pull down to VSS through high
resistance
Keep the pin open
Pull up to VDDE or pull down to VSS through high
resistance
Keep the pin open
Keep the pin open
Keep the pin open
Keep the pin open
Keep the pin open
Pull up to VDDE or pull down to VSS through high
resistance
Keep the pin open
Pull it down to VSS, via high resistance
Keep the pin open
Pull up to VDDE or pull down to VSS through high
resistance.
If the TRACEDATA_x pins (C5, B5, A5, A6) are
unused in multiplex mode #3, then an external
termination is not required because the pins are in
output mode. To make sure that the pins do not
oscillate, check PWMxSR[0] = 0 (i.e. Stop PWM) is
set.
Keep the pin open
Keep the pin open
Pull up to VDDE or pull down to VSS through high
resistance. See also TRACEDATA_0.
1-45