Fujitsu MB86R02 Jade-D Hardware Manual page 333

MB86R02 'Jade-D' Hardware Manual V1.64
Bit init Name
ial
cfg_downBwMode[1]
7 1
cfg_downBwMode[0]
6 1
cfg_ddown_enable
5 0
reserved
4 0
reserved
3 0
reserved
2 0
reserved
1 0
reserved
0 0
Table 17-7 RX config_byte_6
2
In low bandwidth mode pixel stream mode is not supported, therefore use data mode only, see
config_byte_6, bit 5
17-20
config_byte_6
Description
APIX PHY
selects downstream bandwidth mode
11: 1000 MBit/s (Full Bandwidth Mode)
10: 500 MBit/s (Half Bandwidth Mode)
00: 125 MBit/s (Low Bandwidth Mode 1)
01: reserved
Note: downstream bandwidth setting has
to match related transmitter device
configuration
APIX PHY / AShell:
configure downstream data path
0: disable data mode / enable pixel stream
mode
1: enable data mode / disable pixel stream
mode
Note: for proper operation of 'data mode'
the following settings are also mandatory
cfg_pxdata_width[1:0] := '00'
cfg_px_out_ctrl_piggyback[1:0] := '00'
do not change
do not change
do not change
do not change
do not change
2