Reinstalling The Scbs After Installing The Mx960 Router With A Lift; Figure 65: Installing A Lower Rear Fan Tray - Juniper MX960 Hardware Manual

Figure 65: Installing a Lower Rear Fan Tray

Reinstalling the SCBs After Installing the MX960 Router with a Lift

Copyright © 2017, Juniper Networks, Inc.
To reinstall an SCB (see Figure 66 on page
CAUTION: Before removing or replacing an SCB, ensure that the ejector
handles are stored horizontally and pressed toward the center of the SCB.
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Carefully align the sides of the SCB with the guides inside the chassis.
2.
Slide the SCB into the chassis until you feel resistance, carefully ensuring that it is
3.
correctly aligned.
Chapter 16: Installing the MX960 Router
220):
219