Table of Contents
Advertisement
Installing the TX Matrix Rear Fan Tray
Copyright © 2010, Juniper Networks, Inc.
Figure 97: Removing the Rear Fan Tray
To install a replacement rear fan tray (see Figure 98 on page 240):
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Grasp the fan tray by its handles, and insert it straight into the chassis.
2.
Tighten the captive screws on the fan tray faceplate to secure it in the chassis, using
3.
a Phillips (+) screwdriver, number 2.
Chapter 24: Replacing TX Matrix Hardware Components
239
Advertisement
Table of Contents
Troubleshooting
