Installing The T640 Standard Rear Fan Tray; Figure 120: Removing The Standard Rear Fan Tray - Juniper T640 Hardware Manual

Copyright © 2013, Juniper Networks, Inc.

Figure 120: Removing the Standard Rear Fan Tray

Installing the T640 Standard Rear Fan Tray

To install a replacement standard rear fan tray (see
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Grasp the fan tray by its handles, and insert it straight into the chassis.
2.
Tighten the captive screws on the fan tray faceplate to secure it in the chassis, using
3.
a Phillips (+) screwdriver, number 2.
Chapter 17: Replacing T640 Router Hardware Components
Figure 121 on page 236):
235