Figure 190: Tx Matrix Plus Rear Cable Management System; Maintaining The Pic Cables - Juniper M Series Monitoring And Troubleshooting Manual

Hide thumbs Also See for M Series:

Table of Contents

Documentation

Chapter 12: Maintaining the Cable Management System, Cables, and Connectors

to the odd side of the TXP-F13 SIBs in slots 8 through 15 are routed to the lower right

cable management arm, and the cables connected to the even side are routed to the

lower left cable management arm.

Figure 190 on page 359

shows the TX Matrix Plus cable management system.

Figure 190: TX Matrix Plus Rear Cable Management System

Checklist for Maintaining Cables and Connectors on page 351

To maintain the PIC cables, follow these guidelines:

Make sure that you use the cable and connector type that is specified in the appropriate

router hardware guide, especially for the cable and connectors that are not supplied,

such as the single-mode interface (fiber) and multimode interface (fiber).

Make sure that all cable connectors are securely connected. Securely screw in the

cable connector screws.