Installation; Installation Requirements; Installation Procedure - Omron SYSMAC CS Series Operation Manual

Installation

3-1

Installation

3-1-1

Installation Requirements

3-1-2

Installation Procedure

CX-Profibus CD-ROM
44
CX-Profibus Configuration software is required to configure the PROFIBUS
Master Unit before operating the network. Without a valid configuration the
PROFIBUS Master Unit will not be able to achieve data communication with
the slave devices on the network.
The following are the minimum requirements for a PC to install the CX-Profi-
bus configurator software:
• PC Pentium III or higher, 500 MHz minimum
• Operating System:
• RAM:
• Hard disk space:
• Graphics resolution:
• Serial port:
• CD-ROM drive
• Communication cable: Cable CS1W-CN226 to connect to the peripheral
port on the CPU (Not included with CX-Profibus)
This section explains how to install the CX-Profibus Configuration software
and its components for the PROFIBUS Master Unit.
CX-Profibus is provided on a CD-ROM, which contains the following compo-
nents:
• Microsoft .NET Framework
• CX-Profibus FDT Container application.
• CS1/CJ1W-PRM21 Configuration DTMs.
• CX-Server, to allow communication between the PC and the PLC.
• C200HW-PRM21 Configuration DTM.
• Generic Slave Device DTM, to allow slave configuration using GSD files.
• Additional GSD files for several OMRON slave devices.
Note 1. Any older version of CX-Profibus installed on the system, must be unin-
stalled, prior to installing the newer version.
2. Provided with the CD-ROM is a 16-digit installation key, which can be
found on a label on the CD-ROM box. The key is unique to the CD-ROM
and is required to allow full installation of the software. The key is also used
as reference when registering the purchased software with OMRON.
3. If during installation the 16-digit License code was not entered, the pro-
gram will run in demo mode, i.e. it provides all functionality, but for a limited
period of 30 days. After this period has expired, the License code must be
provided to the program, to allow continuation of use.
4. During the limited period of 30 days, the valid License code, as shown on
the CD-ROM case can be entered at anytime when the program is running,
by selecting the License button in the About dialog window.
5. Administrator rights are required to install CX-Profibus.
Windows 2000 SP2 / Windows NT 4.0, SP6 /
Windows XP
256 MB minimum
256 MB minimum
1024 x 768 pixels minimum
RS-232C; COM1 to COM4 supported
Section 3-1