Table of Contents
Advertisement
4. VDC CONTROL MODULE AND HYDRAULIC CONTROL UNIT (VDCCM&H/U)
T
(1)
VDC control module & hydraulic
control unit (VDCCM&H/U)
(2)
Clip
(3)
Bracket
(4)
Rear RH outlet
C: CAUTION
• Wear work clothing, including a cap, protective
goggles and protective shoes during operation.
• Remove contamination including dirt and corro-
sion before removal, installation or disassembly.
• Keep the disassembled parts in order and pro-
tect them from dust and dirt.
• Before disconnecting connectors of sensors or
units, be sure to disconnect the ground cable from
battery.
• Before removal, installation or disassembly, be
sure to clarify the failure. Avoid unnecessary re-
moval, installation, disassembly and replacement.
• Be careful not to burn yourself, because each
part on the vehicle is hot after running.
• Be sure to tighten fasteners including bolts and
nuts to the specified torque.
• Place shop jacks or rigid racks at the specified
points.
General Description
T
T
(3)
(5)
Rear LH outlet
(6)
Secondary inlet
(7)
Primary inlet
(8)
Front LH outlet
(9)
Front RH outlet
VEHICLE DYNAMICS CONTROL (VDC)
(6)
(5)
(4)
(10)
T
VDC-5
(8) (7)
(9)
(1)
(11)
(10)
Pressure sensor
(11)
Damper
⋅
Tightening torque: N
m (kgf-m, ft-lb)
T: 33 (3.4, 24.3)
(2)
VDC00197
Advertisement
Chapters
Table of Contents
