Honda CR-V 1997 Service Manual page 264

Troubleshooting
Troubleshooting Procedures (cont'd)
If the inspection for a particular cod e requires voltage or resistance ch ecks at the ECM/PCM connectors, remove the right
kick panel. Unbolt the ECM/PCM, and connect the backprobe sets and a digital multimeter as described below. Check the
system according to the procedure described for the appropriate code(s) listed on the following pages.
)
How to Usa the Backprobe Sets
Connect the backprobe adapters to the stacking patch cords, and connect the cords to a multi meter. Using the wire insula-
tion as a guide for the contoured tip of the backprobe adapter, gently slide the tip into the connector from the wire side
until it comes in contact w ith the terminal end of the w ire.
Backprobe AdIA.""'----
BACKPROSE SET
07SAZ - 001000A (Two required)
11-62
ECMI
PCM
DIGITAL MULTIMETER
(Commerci.lly .vlil..,..) or
KS-AHM-32-003