Inspection - Honda CR-V 1997 Service Manual

Crankshaft
Inspection
,. Clean the crankshaft oil passages with pipe cleaners
or a suitable brush.
2. Check the keyway and threads.
Alignment
3. Measure the run out on all main journals to make
sure the crank is not bent. The difference between
measurements on each journal must not be more
than the service limit.
Crankshaft Total Indicated Runout:
Standard INew): 0.03 mm 10.001 in) max.
Service Limit: 0.04 mm (0.002 in)
DIAL INDICA TDR
Rotate two complete
revolutions.
~
Support with lathe-
type tool or V-blocks.
Out-of-Round and Taper
4. Measure out-of-round at the middle of each rod and
main journal in two places. The difference between
measurements on each journal must not be more
than the service limit.
Journal Out-cf-Round:
Standard INew): 0.005 mm 10.0002 in) max.
Service Limit: 0.010 mm (0.0004 in)
EB
o
\
(
f f
o
o
o
Measure taper
at edges.
Measure out-of-
round at middle.
f
o
o
o
5. Measure taper at the edges of each rod and main
journal. The difference between measurements on
each journal must not be more than the service
limit.
Journal Taper:
Standard INew): 0.005 mm 10.0002 in) max.
Service Limit: 0.010 mm (0.0004 in)
7-11