Timing Belt
Removal
Replace Ihe liming bell al 105,000 miles (168,000 km)
according to the maintenance schedule (normal condi-
tions/severe conditions), If the vehicle is regularly driven
in either of the following conditions, replace the timing
bell al 60,000 miles (U.S.A.) 100,000 km (Canada).
-
In very high temperatures (over 110°F, 43°C).
-
In very low temperatures (under -20°F, -29°C).
,.
1um the cran\(stlan. pu\\e'l so the No. '\ p\ston
\03
at
lop dead cenler (TOC).
2.
Remove the guard bar and splash shield (see page
5-7).
3.
Loosen the mounting bolt and lock bolt, then remove
Ihe power sleering (PIS) pump bell.
MOUNTING BOLT
ax 1.25 mm
24 N·m (2.4 kgf·m, 17 Ibf.lt)
~~
,
LOCK BOLT
8x1.25mm
24 N'm 12.4 kgf·m, 17 Ibf.lt)
\
PI
PUMP
BELT
4.
Loosen the idler pulley bracket bolt and adjusting
bolt, then remove the air conditioning
(AlC)
compres-
sor belt (see page 5-4),
6-10
5.
Loosen the mounting nut and locknut, then remove
the alternator belt.
LOCKNUT
8x 1.25 mm
24 N'm 12.4 kgf·m, 17 Ibf.ft)
ALTERNATOR
BELT
MOUNTING NUT
10 x 1.25 mm
44 N·m (4.5 kgf'm, 33 Ibf.ft)
6.
Remove the cruise control actuator (see section 4).
7.
Support the engine with a jack, then remove the
upper bracket. Make sure to place a cushion
between the oil pan and the jack.
12)( 1.25
mm
74 N'm 17.5 kgf·m, 54 )bUt)
1\
UPPER BRACKET
~/
~I ~,
I
"
~
\
-
/
•
I